Ask a Question
GoPro Support Hub Ask a question. Share an answer. Find a solution. Stay stoked.
Announcements
Is your GoPro gear up to date? Check to see If it is on our Update page.
Mounts + Accessories
Reply
Sightseer
Posts: 2

impossible de retirer l'objectif de protection

bonjour,

 

Afin de mettre ma GoPro Hero 6 back dans le boitier Super Suit, je dois enlever l'objectif de protection. mais je n'y arrive pas.


Quelqu'un a-t-il une solution?

 

Merci

Amicalement

Explorer
Posts: 12,391

Re: impossible de retirer l'objectif de protection

You must pull out and away from the camera and then twist in a counter-clock direction.

https://youtu.be/K4JFrax5KSw

It can be difficult the first few times.
GoPro
Posts: 3,578

Re: impossible de retirer l'objectif de protection

@sunnygorge1330, here's an additional info that might help.
 

Removal: 

  1. Hold on to camera securely in the palm of one hand, and use your dominant hand to grip the Protective Lens. 
  2. Pull the Protective Lens away from the camera body slightly (≈1mm) and rotate counter-clockwise. NOTE: There will be some resistance during this process due to the water-tight gasket below the Protective Lens. If the Protective Lens fails to rotate at this stage, you may need to vary the amount that you are pulling the lens outward. 
  3. Once rotated 45°, remove the Protective Lens by pulling it away from the camera body. 
  4. Take care to keep debris and fingerprints off of the interior (rounded) lens. 

Installation: 

  1. Ensure that interior lens is free of debris. Only if necessary, clean with a soft, lint-free cloth or lens pen. NOTE: We do not recommend the use of any liquid or solvent when cleaning the interior lens. 
  2. Check for any debris on the waterproof gasket, and clean the Protective Lens if necessary.
  3. Mount the Protective Lens on the camera at a 45° angle. TIP: When looking at the camera from the front, one of the shorter sides of the Protective Lens should be facing the upper-right corner of the camera. 
  4. With even pressure, press the Protective Lens onto the camera body and rotate clockwise, 45°. Stop rotating the Protective Lens when it is aligned with the camera body. 
  5. Check to ensure that the gap between the Protective Lens and camera body is even, not exceeding ≈1mm on any of the four sides. 
Sightseer
Posts: 2

Re: impossible de retirer l'objectif de protection

Merci à tous. J'ai enfin pu enlever le cache. C'est vrai qu'il faut écarter le cache de la caméra avec les ongles avant de le faire pivoter d'1/4. Et ce n'est pas facile.

Je n'ai pas répondu car je n'avais pas la GoPro à mes côtés lorsque j'ai reçu vos explications.