- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
08-03-2018 06:40 AM
fusion studio rendering green on one side
- Mark as New
- Bookmark
- Subscribe
- Permalink
- Email to a Friend
- Report Inappropriate Content
I've got an issue where fusion stitches correctly for the first hour or so of a long file (approx 3hrs) but then one of the cameras disappears and is replaced with green. The footage is all there in the correct folders. Any thoughts what might be going wrong?
Cheers
Alex
Solved! Go to Solution.
Accepted Solutions
08-03-2018 01:13 PM
Re: fusion studio rendering green on one side
- Mark as New
- Bookmark
- Subscribe
- Permalink
- Email to a Friend
- Report Inappropriate Content
Are there other recordings with a similar case?
Is your camera on software v01.80?
What are the SD cards used?
Have you tried playing the front and back files individually to see if there are any issues?
This is just to identify if the issue only happened after the files were rendered.
Please check if your computer meets the minimum system requirements for Fusion Studio.
Let us know how it goes.
Thanks!
Ej
All Replies
08-03-2018 01:13 PM
Re: fusion studio rendering green on one side
- Mark as New
- Bookmark
- Subscribe
- Permalink
- Email to a Friend
- Report Inappropriate Content
Are there other recordings with a similar case?
Is your camera on software v01.80?
What are the SD cards used?
Have you tried playing the front and back files individually to see if there are any issues?
This is just to identify if the issue only happened after the files were rendered.
Please check if your computer meets the minimum system requirements for Fusion Studio.
Let us know how it goes.
Thanks!
Ej
08-04-2018 01:06 PM
Re: fusion studio rendering green on one side
- Mark as New
- Bookmark
- Subscribe
- Permalink
- Email to a Friend
- Report Inappropriate Content
I always thought caching was about the same as pre-rendering. saving the frames to the disk/ram for smooth playback. i just dont really get the caching in fusion. in every tool there is a caching option. if i click on it i expect it to just save those frames to the disk/ram while playing back, so i can review the animation afterwards.