01-23-2019 01:43 PM
I found that once the GoPro fusion software crashes, it would continue to crash even if I did a re-installation. I finally found the trick was to make sure I had deleted any partially rendered files that were left in the output folder. Once I did this, Fusion studio would load back up again without crashing. I also find it's quicker and more reliable to render at Pro-Res, however this will take up a lot of space when it comes to outputted files.
01-28-2019 09:26 AM
Thank you for sharing, @irishmanpdx. This will help others who might be having the same issue.
@stuartp838 . A Beta firmware update for both the Fusion camera and Fusion studio was recently released. There is information here https://gopro.com/help/articles/block/fusion-2-0-beta-update-for-your-gopro-fusion about it that might help with your case. Let us know how it goes.