11-28-2017 12:10 PM - last edited on 03-27-2018 04:46 PM by jefft
64GB 2133 ram
Problem: Low memory error. Uses all 64gb of memory then crashes. I get through 60%+- of a 2:38 clip before the error happens.
This is using Dwarp at 5.2k Cineform with Stabilization. I have tried 3 times and each time the problem persists. I have also restarted the computer and tried other typical troubleshooting methods. I'm working off a 8 Drive Raid array connected via thunderbolt.
The problem seems to happen shortly after all the ram fills up.. using MSI afterburner to monitor.. please see attached picture..
12-11-2017 01:26 PM
@ryanw047 - Sorry for the delay in getting you an answer. We had flagged this to the Fusion team, but didn't have an answer for you. If this is still happening, please give our Support team a call and we'll try to troubleshoot and document the issue with you.
Also, we have just pushed out an update to Fusion Studio. The update notification should appear when you open the app. Please give that a try and see if it helps in your case.
12-26-2017 08:08 PM
i have same issue. posted it here. https://www.reddit.com/r/gopro/comments/7efi32/fusion_studio_crashes/
The update didnt actually fix the ram leak, still an issue with 5.2k. please update fusion studio!