04-27-2018 06:47 AM
Wondering (And hoping!) That this is a Fusion Studio issue and not that the cameras alignment is off internally. My videos were all stitching fine a month ago but now everything is off (see attached) hoping someone can help me figure out. Thanks for the help.
04-27-2018 04:58 PM
The SAME thing is happening to me. A month+ ago, stitching was great, even for subjects within 6 inches from the camera. Now (after an update) stitching is terrible, from 6 inches to infinity. I am trying to discuss with customer support (I think the guy is Jeffery L), but it is very slow process and they are not very transparent with what they are trying to do. If ONLY they would release all previous versions for us to use and test with.
04-27-2018 05:08 PM
Thanks for the update Greg, yeah it's pretty frustrating especially when everything was working great before. Did you update the firmware on your Fusion itself or the new Fusion Studio software?
Either way, please keep me up to date on what customer support comes back to you with. I totally agree about releasing previous versions too, I have been scouring the web for Fusion Studio 1.0 and can't find it anywhere.
Really hope we can get this resolved and that the footage that has been shot can be restitched cleanly, fingers crossed.
04-30-2018 02:16 AM
05-02-2018 08:34 AM
Question for you two who responded to me.... I may have good news. The screen shots I was sending were from just the previews in Fusion Studio, I had not actually rendered out the clip. Once I've actually rendered them they seem to be looking much better, not perfect but not nearly as bad as the screenshot I shared.
Attached below is from another clip that I actually rendered. Wondering if either of you are doing the same thing I did? Best of luck.