Ask a Question
GoPro Support Hub Ask a question. Share an answer. Find a solution. Stay stoked.
Announcements
Is your GoPro gear up to date? Check to see If it is on our Update page.
Cameras
Reply
Sightseer
Posts: 1

Stabilization only front lens

[ New ]

Hi, I have a problems with stabilization at Gopro Fusion.

 

There are some images, that only stabilize the front lens. The back lens is shake. But I made a lot of scenes. So, anytime the stabilization is OK, but othertime no.

 

So, what I can do to fix it?

 

I tried anti-shake and Full Stabilization

 

Thanks


Accepted Solutions
GoPro
Posts: 12,487

Re: Stabilization only front lens

[ New ]

@bráuliol05172, I have a couple of things to check with you in order to further isolate the problem:

  • When did you notice this issue?
  • Has your Fusion camera's footage been this way since you purchased it?
  • Do you get the same result when using the GoPro App on your mobile device to save the content?

You may try to reinstall the firmware update of the camera as it can help correct any errors with the current software installation. Follow the manual update instructions specified on this article: https://gopro.com/help/articles/block/How-to-Update-GoPro-Cameras

 

In addition to this, please provide us the version number of Fusion Studio installed on your computer.

View solution in original post


All Replies
GoPro
Posts: 12,487

Re: Stabilization only front lens

[ New ]

@bráuliol05172, I have a couple of things to check with you in order to further isolate the problem:

  • When did you notice this issue?
  • Has your Fusion camera's footage been this way since you purchased it?
  • Do you get the same result when using the GoPro App on your mobile device to save the content?

You may try to reinstall the firmware update of the camera as it can help correct any errors with the current software installation. Follow the manual update instructions specified on this article: https://gopro.com/help/articles/block/How-to-Update-GoPro-Cameras

 

In addition to this, please provide us the version number of Fusion Studio installed on your computer.