Ask a Question
GoPro Support Hub Ask a question. Share an answer. Find a solution. Stay stoked.
Announcements
Is your GoPro gear up to date? Check to see If it is on our Update page.
Cameras
Reply
Hiker
Posts: 7

Hero 9 stuck after update

[ New ]
I just updated my hero 9 through the app and it said it was successful.

Now after a few hours the camera is unresponsive and the red light keeps blinking.

Accepted Solutions
GoPro
Posts: 14,928

Re: Hero 9 stuck after update

[ New ]

@naikee, please make sure that a recommended SD card is used for your camera. Using SD cards that aren't recommended can cause issues like freezing as the card isn't fast enough to write the content, the camera getting hot or battery consumption is higher than normal as the camera stays in an active mode trying to sync to the card. 
 
Though your camera has the latest firmware installed, reinstalling the firmware update of the camera can also help correct any errors with the current software installation. Using an SD card adapter, connect your microSD card to your computer and follow the Manual Update instructions specified in this article: https://community.gopro.com/t5/en/How-to-Update-GoPro-Cameras/ta-p/394229 

 
Additionally, performing a factory reset in the camera may help. 
 
Let us know how it goes. 

View solution in original post


All Replies
GoPro
Posts: 14,928

Re: Hero 9 stuck after update

[ New ]

@naikee, please make sure that a recommended SD card is used for your camera. Using SD cards that aren't recommended can cause issues like freezing as the card isn't fast enough to write the content, the camera getting hot or battery consumption is higher than normal as the camera stays in an active mode trying to sync to the card. 
 
Though your camera has the latest firmware installed, reinstalling the firmware update of the camera can also help correct any errors with the current software installation. Using an SD card adapter, connect your microSD card to your computer and follow the Manual Update instructions specified in this article: https://community.gopro.com/t5/en/How-to-Update-GoPro-Cameras/ta-p/394229 

 
Additionally, performing a factory reset in the camera may help. 
 
Let us know how it goes.