02-28-2018 10:47 AM
You can reach the GoPro Support Team through the Contact Us tab.
That being said, I don't think these cameras are meant to be used as a 24/7 cam. You'll most likely run into overheating issues and running power to the camera will eliminate the waterproofing. If you put the camera in a waterproof housing and manage to run power to it, then you will have a processor encased in a waterproof camera within a waterproof housing. The heat generated and then trapped will most likely cause the camera to shut down.
There are cameras designed for what you want. Your best route isn't going to be trying to make an action camera function in a way that it wasn't designed. Throw it on a chest mount and run around and have fun on the beach and in the water. That is what this camera is designed for.
02-28-2018 01:01 PM
Seeing this with my hero 6 after update
before update device default mode is looping set for 5 min
after update default mode is set to looping set for MAX change it to 5 min then turn off device its back to MAX.
Was on chat for 2 hrs with them no fix.
02-28-2018 02:20 PM - edited 02-28-2018 02:23 PM
Stabilization seems ok to me. Gimal like. I mostly use the Grip.
Shot with 2.01 firmware, linear mode, wrist strap mount.
02-28-2018 04:26 PM
Ok, that looks a lot better than what I was getting while testing at home last night, so I guess it's reducing or eliminating stabilization in lower light conditions to avoid the weird motion blur effect that causes.
It better adjust on the fly though. Not uncommon to start recording in a low light situation (indoors to outdoors, or just with lens obstructed) to outdoors).