01-23-2019 02:59 AM
I've tried the fixes that I could find but they didn't seem to work. When I first got my Fusion things seemed to work really good, but after the last few uses, the videos started getting really bad stitch lines. I've tried updating the firmware with 1.8 and 2.0 but got the same results. I've also looked at the videos prior to and post rendering of Fusion Studio, but still had the same stitching issues. I inspected the Fusion's lens to see if they were damaged but didn't see or feel anything out of the ordinary. If anyone can think of a fix I would really appreciate it, thanks!
Viewed in Fusion Studio screenshot
Viewed in GoPro VR player
D. Warp turned off
This is how it used to look
01-23-2019 10:06 AM
Yes it is on all the videos. While these videos were taken the camera was aligned with the tripod. Even after I finished editing the footage on Adobe Premier CC, I could still clearly see that gray stitch line.
01-23-2019 08:18 PM
I've updated my firmware to 2.0 beta and still yielded the same results, unfortunately. The screenshots below have the camera aligned with the tripod but the pole can be seen more than usual.
01-24-2019 08:55 AM
Thank you so much for getting back to us and trying the suggested steps.
Please get in touch with our Support Team to move forward with this concern.
They are available by phone or chat through https://gopro.com/help/ContactUs
Let them know of the steps taken so far or you may just refer them to this thread.
Also, please have your camera's serial number and proof of purchase ready.